iHome Headphones iB12 User Manual

Model: iB12  
fitness earbuds  
with clip-on LED safety flasher  
+ cordwrap  
Using Your iHome Headphones  
The earpieces are marked “L” and “R”. Place the “L” earpiece in your left ear  
and the “R” earpiece in your right ear for proper fit and best sound. If the  
earpieces are inserted incorrectly they will not fit properly in your ears and the  
sound quality will not be satisfactory. For added stability the cables of these ear  
buds should be looped over your ears as shown in the following illustration.  
NOTE: Your iB12 headphones are supplied with three different size silicon tips  
(S-M-L) for maximum comfort and to seal out unwanted noise. The “M”  
(medium) size tips were installed at our factory. If you find that the installed tips  
are too small or too large for your ears, you may remove them and replace  
them with the larger or smaller size accessory tips. To replace the tips simply  
pull them off the earpieces. To install different size tips, push them on to the  
earpieces and make sure they are fully seated on each earpiece so that they do not come off when you  
remove the earpiece from your ear. If one of the tips remains in your ear when you remove the  
headphones, remove the tip carefully and avoid pushing it further into your ear canal. Seek medical  
assistance if one of the tips becomes lodged in your ear and you are unable to remove it.  
Connect the headphone plug to the headphone jack of your music player. Be sure that the plug is fully  
inserted into the jack. If the plug is not fully inserted you may only hear sound from one earpiece.  
To protect your hearing, always start listening with the volume control of your music source set to a low  
level and then gradually increase the volume to a comfortable listening level.  
Press here to open belt clip  
LED Safety Flasher  
Your iHome iB12 Ear Buds are supplied with a  
LED safety flasher that includes a convenient  
belt clip and an integrated cord wrap to keep  
your cables tangle free. Remove the battery  
pull tab before use.  
Press the Mode Button on the front panel to  
turn the flasher on and cycle through the 3  
operating modes as follows:  
Mode  
Button  
First press – LEDs ash rapidly  
Second press – LEDs ash slowly  
Slide-out  
Cord Wrap  
Third press – LEDs On’ continuously  
Fourth press – LEDs Off’  
Belt Clip  
Battery  
Compartment  
Replacing Batteries  
Two CR1625 batteries that were installed at our factory should provide sufficient power for up to 96 hours  
of continuous operation. When the lighting effect begins to dim or no longer turns ‘On’ you should replace  
the batteries as soon as practical.  
+
+
LITHIUM BATTREY  
CR1625  
3V  
-
-
-
+
Remove the battery  
pull tab before use  
To open, unscrew center screw  
only and pull out the batteries tray  
Install two fresh CR1625 batteries  
in the battery tray as shown above  
 

Grizzly Planer G0453Z User Manual
Grundig MP3 Player 30GB User Manual
HANNspree Flat Panel Television K223 10A1 User Manual
Hasbro Games 06539 User Manual
Hasselblad Camera Lens HC 45 300 User Manual
Hatco Water Heater IMPERIAL S User Manual
Hearth and Home Technologies Indoor Fireplace CD4236ILR User Manual
Heat Controller Heat Pump VMC09SB 1 VMH09SB 1 User Manual
HP Hewlett Packard Switch PRO RX User Manual
IBM Blood Glucose Meter 5697 VM3 User Manual