Humminbird Fish Finder 530501 1_B User Manual

1
530501-1_B  
Flush Mount Temp/Speed Gauge  
Thru-Hull Installation  
Thank You  
Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation by designing  
and manufacturing top-quality, thoroughly reliable marine equipment. Genuine Humminbird® accessories offer the  
opportunity to upgrade and expand the capabilities of your Humminbird® product.  
Your Humminbird® is designed for trouble-free use in even the harshest marine environment. In the unlikely event that your  
Humminbird® does require repairs, we offer an exclusive Service Policy - free of charge during the first year after purchase, and  
available at a reasonable rate after the one-year period. For complete details, see the Warranty section included in this manual.  
Contact our Customer Resource Center at either 1-800-633-1468 or visit our website at www.humminbird.com.  
Installation Overview  
Following are instructions for the installation of this accessory. Before you start installation, we encourage you to read these  
instructions carefully in order to get the full benefit from your Humminbird® accessory.  
Areas of Possible Turbulence  
If you find that any items are missing from your installation kit, call our Customer Resource Center at 1-800-633-1468 or  
visit our website at www.humminbird.com.  
NOTE: This accessory requires drilling a hole in the hull of the boat; therefore, installation should be performed by a qualified  
marine technician.  
In addition to the hardware supplied with your accessory, you will need a drill, a small drill bit for a pilot hole, a 2" hole saw,  
a level, and marine-grade silicone sealant.  
Installation  
Perform the procedures in the following sections to install the Temp/Speed Gauge on your boat.  
Rivets  
Transom  
Hull  
1.  
Testing the Temp/Speed Gauge Prior to Installation  
Strakes  
Prior to installation, test the Temp/Speed Gauge to make sure that no damage occurred during shipping.  
1. After connecting the temp/speed gauge to the control head, hold the gauge in the water over the side of the boat to  
confirm proper operation. If the gauge is working properly, the control head will begin displaying water temperature  
immediately.  
Stepped Hull  
2.  
Locating the Temp/Speed Gauge Mounting Position  
You must first determine the best location on the transom to install the Temp/Speed Gauge. It is very important to locate the  
gauge in an area that is relatively free of turbulent water, constantly submerged, and positioned to allow you to trailer the  
boat without damaging the gauge.  
The best location will be aft midship, as close to the centerline of the boat as possible. The gauge should be mounted  
forward of the prop(s) on inboard boats, and separate from other transducers, strakes, rivets, ribs, or other protrusions.  
Rib  
Step  
Inside the boat, there must be room to access the mounting location for installation and cable routing. Notice that the  
Temp/Speed Gauge is removable from the threaded housing - adequate overhead space must be available to remove  
this insert.  
3.  
Attaching the Temp/Speed Gauge  
1. From the outside of the hull, drill a small pilot hole (smaller than the centering bit of your drill bit or hole saw), at the  
mounting location you selected in procedure 2.  
2. Use the pilot hole (from the outside of the hull) to drill a 2" hole.  
3. Thoroughly clean and deburr the drilled hole and clean the outside of the hull.  
4. Disassemble the temp/speed gauge and wing nut from the threaded housing.  
© 2008 Humminbird®, Eufaula AL, USA.  
All rights reserved.  
 
3
530501-1_B  
Flush Mount Temp/Speed Gauge  
Maintenance  
Humminbird® Service Policy  
If your boat remains in the water for long periods of time, algae and other marine  
growth can reduce the effectiveness of the Temp/Speed Accessory. Periodically  
clean the face of the Temp/Speed Accessory with hot water.  
Even though you'll probably never need to take advantage of our incredible  
service policy, it's good to know that we back our products this confidently. We do  
it because you deserve the best. We will make every effort to repair your unit  
within three business days from the receipt of your unit at our factory. This does  
not include shipping time to and from our factory. Units received on Friday are  
typically shipped by the following Wednesday, units received Monday are  
typically shipped by Thursday, etc.  
If your boat remains out of the water for a long period of time, it may take some  
time to wet the Temp/Speed Accessory after it is returned to the water. Small air  
bubbles can cling to the surface of the gauge and interfere with proper operation.  
These bubbles will dissipate with time, or you may wipe the face of the  
Temp/Speed Accessory with your fingers after the gauge is in the water.  
All repair work is performed by factory-trained technicians to meet exacting  
factory specifications. Factory-serviced units go through the same rigorous testing  
and quality control inspections as new production units.  
1-Year Limited Warranty  
After the original warranty period, a standard flat rate service charge will be  
assessed for each repair (physical damage and missing parts are not included).  
Any repairs made after the original warranty will be warranted for an additional  
90 days after service has been performed by our factory technicians. You can  
contact our Customer Resource Center or visit our website to verify the flat rate  
repair fee for your product (visit the Product Support section):  
We warrant the original retail purchaser that products made by Humminbird®  
have been manufactured free from defects in materials and workmanship. This  
warranty is effective for one year from the date of original retail purchase.  
Humminbird® products found to be defective and covered by this warranty will be  
replaced or repaired free of charge at Humminbird® option and returned to the  
customer freight prepaid. Humminbird® sole responsibility under this warranty is  
limited to the repair or replacement of a product that has been deemed defective  
by Humminbird®. Humminbird® is not responsible for charges connected with the  
removal of such product or reinstallation of replaced or repaired parts.  
We reserve the right to deem any product unserviceable when replacement parts  
are no longer available or impossible to obtain. This Service Policy is valid in the  
United States only. This applies only to Humminbird® products returned to our  
factory in Eufaula, Alabama. This Service Policy is subject to change without  
notice.  
This warranty does not apply to a product that has been:  
• Improperly installed;  
• Used in an installation other than that recommended in the product  
installation and operation instructions;  
• Damaged or has failed because of an accident or abnormal operation;  
• Repaired or modified by entities other than Humminbird®.  
Please retain your original receipt as a proof of the purchase date. This will be  
required for in-warranty service.  
THIS WARRANTY IS EXPRESSLY IN LIEU OF ANY OTHER WARRANTIES,  
OBLIGATIONS OR LIABILITIES ON THE PART OF HUMMINBIRD® AND WILL BE  
THE CUSTOMER'S EXCLUSIVE REMEDY, EXCEPT FOR ANY APPLICABLE IMPLIED  
WARRANTIES UNDER STATE LAW WHICH ARE HEREBY LIMITED IN DURATION  
TO ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE. IN NO EVENT WILL  
HUMMINBIRD® BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL  
DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY RELATING  
TO THE PRODUCTS.  
Some states do not allow limitations on an implied warranty, or the exclusion of  
incidental or consequential damages, so the above exclusions may not apply to  
you. You may also have other rights, which vary from state to state.  
© 2008 Humminbird®, Eufaula AL, USA.  
All rights reserved.  
 
4
530501-1_B  
Flush Mount Temp/Speed Gauge  
Returning Your Unit for Service  
Contact Humminbird®  
Before sending your unit in for repair, please contact the factory, either by phone  
or by email, to obtain a Repair Authorization Number for your unit. Please have  
your product model name and serial number available before calling the factory.  
If you contact the factory by e-mail, please include your product model name and  
serial number in the e-mail, and use Request for Repair Authorization Number for  
your e-mail subject header. You should include your Repair Authorization Number  
in all subsequent communications about your unit.  
Contact the Humminbird® Customer Resource Center  
in any of the following ways:  
By Telephone  
(Monday - Friday 8:00 a.m. to 4:30 p.m. Central Standard Time):  
1-800-633-1468  
For IN-WARRANTY service, complete the following steps:  
By e-mail  
(typically we respond to your e-mail within three business days):  
• Obtain a Repair Authorization Number from the Humminbird® Customer  
Resource Center.  
• Tag product with your name, street address, phone number and your  
assigned Repair Authorization Number.  
For direct shipping, our address is:  
• Include a brief written description of the problem.  
Humminbird  
• Include a copy of your receipt (to show proof and date of purchase).  
Service Department  
678 Humminbird Lane  
Eufaula, AL 36027 USA  
• Return product freight prepaid to Humminbird®, using an insured carrier  
with delivery confirmation.  
For OUT-OF-WARRANTY service, complete the following steps:  
• Obtain a Repair Authorization Number from the Humminbird® Customer  
Resource Center.  
• Include payment in the form of credit card number and expiration date,  
money order or personal check. Please do not send cash.  
• Tag product with your name, street address, phone number and your  
assigned Repair Authorization Number.  
• Include a brief written description of the problem.  
WARNING! Disassembly and repair of this electronic unit should only be  
performed by authorized service personnel. Any modification of the serial  
number or attempt to repair the original equipment or accessories by  
unauthorized individuals will void the warranty.  
• Return product freight prepaid to Humminbird®, using an insured carrier  
with delivery confirmation.  
© 2008 Humminbird®, Eufaula AL, USA.  
All rights reserved.  
 

Graco Crib ISPP046AC 04 User Manual
Grandstream Networks Cordless Telephone Handy Tone 386 User Manual
Greenway Home Products Water Dispenser VWD5206W User Manual
Grindmaster Coffeemaker Single Cup Pod Brewer User Manual
Grizzly Chainsaw Sharpener T23107 User Manual
Honeywell Bluetooth Headset AP 010 BT User Manual
Hotpoint Oven SE101PGX User Manual
HP Hewlett Packard Network Router N1200 User Manual
ICP DAS USA Modem SST 2450 User Manual
IKEA Double Oven DOV8 2 User Manual