Harbor Freight Tools Work Light 96141 User Manual

16 LED spotLight  
with hanD crank  
Model 96141  
assEMbLy anD opEration instructions  
Due to continuing improvements, actual product may differ slightly from the product described herein.  
®
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Visit our website at: http://www.harborfreight.com  
to prEVEnt sErious injury, rEaD anD unDErstanD  
aLL warnings anD instructions bEforE usE.  
©
®
Copyright 2007 by Harbor Freight Tools . All rights reserved. No portion of this  
manual or any artwork contained herein may be reproduced in any shape or form  
without the express written consent of Harbor Freight Tools.  
for technical questions or replacement parts, please call 1-800-444-3353.  
 
2.  
3.  
keep bystanders, children, and visitors away while using this product. Distrac-  
tions can cause you to lose control.  
stay alert. watch what you are doing, and use common sense when operat-  
ing the spotlight. Do not use this product while tired or under the inuence  
of drugs, alcohol, or medication. A moment of inattention while operating this  
product may result in serious personal injury.  
4.  
5.  
Do not force the product. use the correct product for your application. The  
correct product will do the job better and safer at the rate for which it is designed.  
Do not force the product and do not use the product for a purpose for which it is  
not intended.  
store idle products out of reach of children and other untrained persons. This  
product is dangerous in the hands of untrained users. Never point the light beam  
directly at people or animals.  
6.  
7.  
Maintain this product with care. Do not use a damaged product. Tag damaged  
products “Do not use” until repaired.  
check for misalignment or binding of moving parts, breakage of parts, and  
any other condition that may affect the products operation. if damaged,  
have the product serviced before using. Many accidents are caused by poorly  
maintained products.  
8.  
9.  
Maintain labels and nameplates on the product. These carry important informa-  
tion. If unreadable or missing, contact Harbor Freight Tools for a replacement.  
Maintain a safe working environment. Make sure there is adequate surrounding  
workspace. Do not use this product in a damp or wet location.  
unpacking  
When unpacking, check to make sure that the item is intact and undamaged. If any  
parts are missing or broken, please call Harbor Freight Tools at the number shown on the  
cover of this manual as soon as possible.  
SKU 96141  
for technical questions, please call 1-800-444-3353.  
Page 3  
 
opEration  
1.  
2.  
The Spotlight can be charged in three different ways by cranking the Handle, using  
the 120 V~ Adapter, or using the Cigarette Plug Adapter.  
The Green LED will indicate when the battery is fully charged. A red LED will indi-  
cate that the battery is charging.  
charging with the cranking handle  
Figure 1  
Handle  
Charge  
Indicator LED’s  
1.  
2.  
Pull out the Handle as shown in Figure 1.  
Grasp the Handle and crank it continuously clockwise. The red LED will stay on while  
the Spotlight is charging. For every 3 minutes of turning the handle you will get one  
minute of light. The Green LED will come on when the Spotlight is fully charged.  
3.  
When finished, fold the Handle back into its slot when done cranking.  
using the cigarette plug adapter  
Insert the plug end into the charge receptacle on the Spotlight.  
Plug the Cigarette Plug Adapter into the vehicle’s cigarette lighter socket.  
Allow the Spotlight to charge until the green LED comes on.  
1.  
2.  
3.  
4.  
To prevent the vehicle’s battery from running down, charge the spotlight only when  
the vehicle’s engine is running.  
5.  
The Green LED will come on when the Spotlight is fully charged.  
SKU 96141  
for technical questions, please call 1-800-444-3353.  
Page 4  
 
using the 120 V ac/Dc adapter  
Insert the plug end into the charge receptacle on the Spotlight.  
Plug the 120V AC/DC Adapter into a 120V receptacle.  
Allow the Spotlight to charge until the green LED comes on.  
1.  
2.  
3.  
4.  
Remove the 120V AC/DC Adapter electrical plug from the outlet, and disconnect  
from the Spotlight.  
running the spotlight  
1.  
The Spotlight will run for approximately 28 hours on a fully charged battery while in  
LOW mode, and approximately 12 hours on a fully charged battery while in HIGH  
mode.  
2.  
3.  
4.  
The LOW setting will run 6 LED’s while the HIGH setting will use all 16 LEDs.  
Select HIGH or LOW modes to run the Spotlight by moving the switch.  
Squeeze the Trigger to turn ON the Spotlight.  
Trigger Lock  
Trigger  
Figure 2  
5.  
6.  
Slide theTrigger Lock Switch down (see Figure 2) to lock theTrigger ON. To release  
the Trigger from locked position, lightly touch the Trigger.  
Remove finger away from the Trigger to turn the Spotlight OFF.  
inspEction, MaintEnancE, anD cLEaning  
1.  
2.  
warning! Make sure the Trigger is in its “OFF” position before performing  
any inspection, maintenance, or cleaning procedures.  
bEforE Each usE, inspect the general condition of the Spotlight. Check for  
cracked or broken parts and any other condition that may affect its safe operation.  
If abnormal noise or vibration occurs, have the problem corrected before further  
use. Do not use damaged equipment.  
SKU 96141  
for technical questions, please call 1-800-444-3353.  
Page 5  
 
3.  
4.  
protect the spotlight from rough use. It is susceptible to damage from being  
dropped, struck or other abuse.  
protect the spotlight from exposure to water or corrosive materials. It should  
be kept clean and dry. Occasional cleaning with a clean rag will extend its life and  
good appearance.  
5.  
6.  
Lock it up and store in a dry location to inhibit rust. Keep out of the reach of  
children.  
before discarding this product, remove the battery and dispose of it properly  
in accordance with local, state and federal regulations and ordinances. To  
access the battery, remove the six small phillip’s-head screws that secure the back  
and the front part of the housing. Then remove 4 screws holding the two halves of  
the housing together. Be careful with the battery, it may leak acid. Wash off any  
spilled acid immediately with cool water.  
note: The LED lights have a long lifetime and do not need replacement. The Spotlight  
has no replacement parts.  
SKU 96141  
for technical questions, please call 1-800-444-3353.  
Page 6  
 

Graco Inc Heat Pump 3A1450D User Manual
Gravely Lawn Mower 41193 User Manual
Harman Portable Speaker Spyro User Manual
Health O Meter Scale 400KL User Manual
Heatcraft Refrigeration Products Refrigerator BN PL0208 User Manual
Hotpoint Washer WMXTF 742 User Manual
HP Hewlett Packard All in One Printer 7140xi User Manual
HP Hewlett Packard Flat Panel Television LT3700 User Manual
HP Hewlett Packard Projector B6960 96035 User Manual
Hypertec Carrying Case 5703 User Manual