Harbor Freight Tools Mobility Aid 92987 User Manual

SMALL SIT OR STAND WALKER  
WITH HAND BRAKE  
92987  
ASSEMBLY & OPERATING INSTRUCTIONS  
®
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Copyright© 2005 by Harbor Freight Tools®. All rights reserved. No portion of this manual or  
any artwork contained herein may be reproduced in any shape or form without the  
express written consent of Harbor Freight Tools.  
For technical questions and replacement parts please call 1-800-444-3353.  
 
11. Do not allow children to play with, stand upon or climb on the Walker.  
12. Always check hardware and assembled parts after assembling. All connections should be  
tight and hardware tightened.  
SPECIAL WARNINGS FOR THIS PRODUCT  
1. Before use, make certain your Walker is fully opened, the seat is down completely, and  
the folding bar beneath the seat is in the locked position.  
2. Check that both handles are at equal heights. If one is lower than the other, adjust  
accordingly. Apply gentle pressure to the Handles to test the stability of the Walker before use.  
3. Test brakes thoroughly before use. The brake bar on the wheels will prevent the wheels from  
rolling when the brake is set in the locked position. If the wheels turn while the brakes are  
locked, have the brakes adjusted by an authorized technician. Under no circumstances should  
you use this product if the brakes do not lock properly.  
4. Always put brakes in the locked position before sitting on the seat. Do not sit on the seat  
unless you are on even, level ground.  
5. Check tires periodically and replace when worn.  
6. This product is not a cart or a wheel chair. Do not use it to push or carry people or objects  
(except for objects in the basket). Do not load more than 25 Lbs. in the basket.  
7. Do not exceed the maximum load capacity of 250 Lbs.  
Warning:  
The warnings, cautions, and instructions discussed in this instruction manual cannot  
cover all possible conditions and situations that may occur. It must be understood by  
the operator that common sense and caution are factors which cannot be built into  
this product, but must be supplied by the operator.  
Unpacking  
When unpacking your Walker, check to make sure that all of the parts listed on page 5 are included.  
If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353.  
Assembly  
Your Walker will require minor assembly before use. It is important that you read the entire manual  
to become familiar with the product BEFORE you use the Walker. Before using the Walker, check to  
make sure that the product is intact, undamaged and working properly.  
Handles  
If not already in place, set one Collar (21) securely onto each side of the Front Frame (20). Insert  
the Handle (10) down into the Front Frame (20). Loosen the Knob (22) and insert the Handle (10)  
down through the Collar (21) on each side of the Handle (10)-see Figure 1. Repeat these assembly  
steps for the other Handle (10).  
Attaching the Back rest Bar (6)  
1.  
Insert both ends of the Backrest Bar (6) with Foam Tubing (7) down into the fitting located at  
the front of the Front Frame (20)-see Figure 2. To do so you must pull out the Pin located on  
the front of the fitting. While pulling up on the Pin, insert the Bolt (8) located on the Backrest  
Bar (6) down into the fitting. Release the Pin-see Figure 2.  
SKU 92987  
For technical questions please call 1-800-444-3353.  
Page 3  
 
2.  
Pull up on the Backrest Bar (6) to make certain that it is securely locked into place.  
Attaching the Basket (9)  
Hang the Basket (9) from the bar located direclty beneath the Plastic Seat (1) and rest the fitted  
bottom of the Basket (9) onto the bar at the bottom of the Walker.  
Once the Walker is completely assembled, test it to make certain that it folds and unfolds  
properly, that the wheels roll, and that the brakes work. Make certain that it is stable and that  
all hardware is securely tightened.  
Operation  
1.  
To slow down or stop temporarily, squeeze the Handgrip (3) and the Brake Loop (2) together  
firmly.  
Figure 2  
Figure 1  
Handle (10)  
Knob (22)  
Bolt (8)  
Collar (21)  
Front Frame (20)  
Pin  
2.  
To lock the 6” Wheels (18) in place, with your foot push down on the Brake Lock (12) over  
each rear 6” Wheel (18). Make certain that the Brake Lock (12) is securely in place and that  
the 6” Wheels (18) are securely locked.  
3.  
4.  
To unlock the 6” Wheels (18), release the tab on each Brake Lock (12) with your foot.  
The Rollator Walker is easily collapsible when you want to take it in the car, on an airplane, or  
for other storage purposes. Simply remove the Basket (9) and pull up on the grip opening  
on the Plastic Seat (1).  
To unfold the Rollator Walker, place all of the 6Wheels (18) on the ground and push down on  
the Plastic Seat (1) until the Walker fully opens. Make certain that the Walker is stable before  
using it.  
Warning :  
This Walker should only be used by a person who needs some assistance while  
walking. Responsible adult supervision is required if the user is unstable and  
especially when the user is getting in and out of the seat.  
PLEASE READ THE FOLLOWING CAREFULLY  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE  
TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF  
ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR  
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR  
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND  
LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF  
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR  
HER INSTALLATION OF REPLACEMENT PARTS THERETO.  
SKU 92987  
For technical questions please call 1-800-444-3353.  
Page 4  
 
PARTS LIST  
Part # Description  
Quantity Part # Description  
Quantity  
1
2
3
4
5
6
7
8
Plastic Seat  
Brake Loop  
Hand Grip (right/left) 1  
Control Plate  
Brake Cable  
Backrest Bar  
FoamTubing  
Bolt  
Basket  
Handle  
Back Frame  
Brake Lock  
1
2
13  
14  
15  
16  
17  
18  
19  
20  
21  
22  
Wheel Fork Bearing Cap  
2
2
2
4
2
4
8
2
2
1
Cross Bar  
L-Shape Joint  
Bearing  
Wheel Fork  
6Wheel  
Nut Cap  
Front Frame  
Collar  
Knob  
2
2
1
1
2
1
1
2
2
9
10  
11  
12  
PARTS DIAGRAM  
22  
21  
20  
SKU 92987  
For technical questions please call 1-800-444-3353.  
Page 5  
 

Haier Water Heater S110ENF User Manual
Hamilton Beach Coffeemaker 48131 User Manual
HannsG Stereo Amplifier HA4600 User Manual
Hasbro Games 06706 User Manual
Hotpoint Washer Dryer AQGMD 129 User Manual
HP Hewlett Packard Personal Computer vl410 User Manual
Hunter Fan Fan 21894 User Manual
Hypertec Carrying Case N14608PHY User Manual
IBM Switch 12122EA6 User Manual
ICP DAS USA Modem SST 2450 User Manual