Haier Clothes Dryer HWS60 40 User Manual

Spin-dryer User's manual  
This manual is for  
HWS60-40  
HWS60-50  
Please read this manual  
carefully before using.  
Retain it for future reference.  
 
Names of the parts  
Cover of the spin tub  
Knob of spin timer  
Inner cover  
Panel support  
Water-filling entrance  
Control panel  
Power line  
Handle  
Spin tub  
Drain hose  
Cabinet  
Back cover  
Base frame  
Fixing leg  
(four pieces)  
Note:The figures in this manual can only be regarded as diagrammatic sketches.  
Please understand that, due to constant improvement of design, the extractor  
and its accessories that you have purchased may be inconsistent with these  
figures in the manual.  
Meaning and description of the symbols  
Contents marked with that symbol are related  
Warning sign  
to the safety of the product and the personal  
safety of the users. Please operate in strict  
conformity to the contents, otherwise it may  
cause damage of the machine or injure the  
personal safety of the user.  
Contents marked with that symbol are actions  
Forbidding sign  
forbidden to perform. Performing of those  
actions may result in damage of the machine  
or injure the personal safety of the user.  
Please check if the power receptacle has good earthing  
condition before using to guarantee your safety.  
 
Safety precautions  
When the machine is normally using,  
Please insert the power cord into special  
receptacle with rated voltage.Be sure to  
use single-phase three pins receptacle.If  
possible,please adopt electric leakage  
protector.  
please put the power plug at the loc-  
ation easily to be inserted and extracted  
by hand. Be sure to pull the plug off when  
there's power failure, or the machine is  
being moved, cleaned or when it is idle.  
Do not bend, stretch, twist, bind the power cord by force,  
or reform it. Do not press or clamp it with heavy items.  
Keep the prong of the power plug clean.  
If dust is found on the power plug, please wipe it off with dry cloth.  
If the power cord and power plug are bad, or the receptacle is loose,  
be sure to have it replaced by the technicians of our special shop  
or our agent, or the after-sale service department for the sake  
of avoiding any risk.  
In case the spin dryer is installed  
on ground with carpet , do not block  
the ventilation hole with carpet.  
Do not share one receptacle with other  
electric appliances. Do not use it in  
case that the power plug is damaged  
or the inserting into the receptacle is  
loose.  
Ventilation hole at  
the bottom of the  
spin dryer  
Do not put the machine at damp place  
like the bathroom . Never wash it with  
water. Do not place wet laundries on the  
control panel.  
Do not wash water-proof laundries  
such as the raincoat, bicycle shelter  
etc. To avoid abnormal vibration  
during spinning.  
 
Safety precautions  
Do not stretch hands into the working  
Do not decompose, repair or alter the  
machine by yourself.  
machine. It is dangerous even if the  
rotation is slow. Take special care of  
the children.  
Do not put any hot or heavy items  
( such as the kettle with hot water )  
on the washing machine.  
Do not wash laundries with volatile  
materials (such as thinner, petrol etc.).  
l
ro  
et  
er  
P
inn  
Th  
Keep the machine away from direct  
sunlight and heat source like the  
heater.  
Handicapped or children without care  
shall not use the machine.  
Slanting or uneven ground may result in unstable working or abnormal noise.  
Please make the machine stand horizontally.  
 
The musts in using  
Usage of the panel  
OFF  
OFF  
5
1
10  
2
4
4
2
8
3
6
SPIN TIMER  
WATER INLET  
SPIN TIMER  
Set the spinning duration  
Water-added rinsing-  
spinning,to be used  
Set the spinning duration  
depending on the category  
and amount of the articles.  
depending on the category  
and amount of the articles.  
during defoaming  
-spinning.  
To set to below 1 minute, first  
set to 2 minute then turn it  
back. it can increase the  
service life of the timer  
To set to below 2 minute, first  
set to 4 minute then turn it  
back. it can increase the  
service life of the timer  
HWS60-40  
HWS60-50  
Usage of the drain hose  
The drainage shall be smooth with the drain hose.  
1.The height of the drain hose shall be less than  
10cm , or the drainage will not be smooth enough  
and cause incomplete drainage.  
<10cm  
2. Do not tramp or press the drain hose.  
3. If the drain hose is too long, cut it at mid point.To make  
smooth drainage, cut the front end of the hose slantingly.  
4.If extra drain hose is needed , please make separate  
purchase. The inner diameter of the extra hose shall  
not less than 30mm, and the length shall not exceed  
1.5m.  
>
30mm  
<1.5m  
Using sequence  
Preparation before spinning  
Please make the machine stand horizontally.  
Confirm that the washing machine is earthed reliably . Then insert the power plug  
Into the receptacle. Do not connect the earth terminal to the gas pipe and tap  
water pipe.  
Put down the drain hose .  
 
Spin process  
Put the laundries in properly  
1
2
3
Put the gland in properly  
Close the inner and outer cover of the spin tub  
4
Do you need water-added Rinsing-spinnning  
Water-added rinsing-spinning has an effect that can remove the surplus liquid dirt,  
It works in a way as follows:  
Foam-removing  
spinning  
Spin  
Spin for about  
1~2 minutes  
Remove most of  
the foam extra  
detergent liquid.  
Fill water for  
about 1 minutes  
Spin for about  
1~2 minutes  
Remove the detergent  
liquid remained  
Note: If there needs no water-added rinsing-spinning , set the duration for  
spinning directly.  
The effect is best when the laundries quantity is below 80% of the rated value.  
5
Take the laundry out when the spinning ends.  
When the spinning ends, open the top lid and the interior lid. Then take out  
the depression cover and laundry after the spinning drum has stopped  
rotation completely.  
Note:  
Refer to the Notes on Spinning carefully.  
If you need water-added rinsing-spinning , please check the connection  
between the waterhose and fillinginlet.  
Install the water inlet hose  
Water inlet hose  
The water hose should be connected  
as shown in the right figure.  
Water inlet entrance  
Notes on Spinning  
Use the foam-removing spin-  
Please put in the gland properly even if the laundries  
quantity is small.  
Do not leaveany articles above the depression cover.  
ning to remove the extra deter-  
gent liquid. It can both shorten  
the washing time and save the  
water consumption.  
.
Push  
Gland  
Push  
The laundries  
are slanting  
Proper  
Proper No gland  
 
Disposal after spinning  
1
2
3
4
Hang up the drain hose.  
Pull off the power plug and hang up the power cord.  
Wipe the complete unit with soft cloth twisted dry.  
Open the inner/outer cover of the spin tub for some time (about one hour),  
then close them.  
Maintenance  
If the cabinet is dirty, wipe it with wet soft cloth  
Do not wash it directly by water.  
1
2
Wipe off the water drops on  
the surface and inside the  
tub with clean soft cloth.  
Be sure to pull off the power  
plug before maintenance.  
Wipe with neutral detergent if too dirty  
Petrol  
Thinner  
Do not wipe with thinner, petrol,  
alcohol, etc.  
Alcohol  
Trouble-shooting Answer to question  
(If there's breakdown, please pull off the power plug before checking) The following  
phenomena are not breakdowns sometimes. Please confirm again before sending  
it to repair. If there are real breakdowns, please come to the special maintenance  
department or after-sale service department of our company. Do not repair it by yourself.  
Phenomena  
The reason-How to solve  
Is there power failure--Please use it when there's power supply.  
The machine does not act.  
Insert the power plug tightly.  
Is the power plug loose--  
Is the machine slanting--Adjust the machine to be even  
Is the gland pressed evenly--  
Check if the laundry is inclined to one side--Take it  
Put the gland in properly  
There's abnormal sound  
and violent vibration  
during spinning  
out and replace it evenly.  
Check if thereare any metalarticles in thelaundry.  
-- take themout.  
Check if itis too full with thelaundry-- load thelaundry  
only in theright amount.  
Check if there are any articles out of the spinning drum  
-- put them into the drum.  
 

Grindmaster Food Warmer BW 2 User Manual
Healthrider Home Gym HREL49010 User Manual
Healthrider Treadmill HMTL399061 User Manual
Honeywell Thermostat CT3500 User Manual
Hoshizaki Ice Maker KM 101BAH User Manual
HP Hewlett Packard Computer Drive 460i User Manual
HP Hewlett Packard Personal Computer c3700 User Manual
Hunter Fan Fan 23881 User Manual
Husky Battery Charger HSK1084HD User Manual
Husqvarna Trimmer 250PS User Manual